Table of Contents
Advertisement
Figure 120. Installing a cooling fan
Next steps
1.
Install the 1U air
shroud.
2.
Install the 2U air
shroud.
3. Follow the procedure listed in
Fan board
This is a service technician replaceable part only.
Removing a fan board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the 1U air
shroud.
5.
Remove all the
fans.
NOTE:
The procedure to remove the fan board is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Using the Phillips 2 screwdriver, loosen the two thumb screws and lift the metallic bar away from the system.
2. Using the Phillips 2 screwdriver, remove the screws and using the Phillips 1 screwdriver remove the standoff screw securing
fan board to the chassis . Holding the fan board, lift it away from the system.
148
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
