Table of Contents
Advertisement
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using the Torx 8, remove screws from Status LED control panel assembly.
3. Hold the Status LED control panel assembly and remove the Status LED control panel along with the cable from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 164. Removing the Status LED control panel for Front Accessed configuration
Figure 165. Removing the Status LED control panel for Rear Accessed configuration
Next steps
Replace the Status LED control
190
Installing and removing system components
panel.
Advertisement
Table of Contents
