Table of Contents
Advertisement
Figure 121. Removing a fan board
Next steps
1.
Replace a fan
board.
Installing a fan board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the 1U air
shroud.
5.
Remove all the
fans.
NOTE:
The procedure to install the fan board is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Align and insert the fan board into the slots until it is seated firmly. Tighten the screws using a Phillips 2 screwdriver and the
standoff screw with a Phillips 1 screwdriver to secure the fan board into the chassis.
2. Route the fan cables properly to prevent the cables from being pinched or crimped.
3. Align and lower the metallic bar into the system. Using the Phillips 2 screwdriver, tighten the two thumb screws to secure
the bar into the chassis.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
149
Advertisement
Table of Contents
