Table of Contents
Advertisement
Figure 163. Installing the TPM
Initializing TPM for users
Steps
1. Initialize the TPM.
For more information, see
2. The TPM Status changes to Enabled, Activated.
Initializing the TPM 2.0 for users
Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.
Control panel
This is a service technician replaceable part only.
Removing the Status LED control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the 1U air
shroud.
5. Remove the
Expansion card riser
6. Remove the
Expansion card riser
NOTE:
The procedure to remove the Status LED control panel is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Disconnect the Status LED control panel cable from the system board connector.
Initializing the TPM 2.0 for
Safety
instructions.
Before working inside your
2.
1.
users.
system.
Installing and removing system components
189
Advertisement
Table of Contents
