Next steps
1. If removed,
install the front
2.
Install the air
shroud.
3. Follow the procedure that is listed in
Removing the BOSS-N1 card carrier
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. If installed,
remove the front
Steps
1. Open the release latch and slide the BOSS-N1 card carrier out of the BOSS-N1 module.
Figure 70. Removing the BOSS-N1 card carrier
2. Using the Phillips 1 screwdriver removes the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1
card carrier.
3. Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
104
Installing and removing system components
bezel.
After working inside your
Safety
instructions.
Before working inside your system
bezel.
system.
.