Table of Contents
Advertisement
Figure 115. Removing a filler bracket from Riser 3
3. Hold the expansion card by the edges, and align the card edge connector with the expansion card connector on the riser.
4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
5. Close the expansion card retention latch.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 116. Installing a full-height expansion card into Riser 3
Next steps
1. If applicable, connect the internal cables to the expansion card.
2.
Install the Expansion card riser
1.
Installing and removing system components
143
Advertisement
Table of Contents
