Table of Contents
Advertisement
Figure 56. Installing a E3.S drive
Next steps
Install the front
bezel.
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2.
Remove the drive
carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE:
If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) screwdriver to remove the drive.
2. Lift the drive out of the drive carrier.
92
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
