Table of Contents
Advertisement
Figure 131. Installing a memory module
Next steps
1.
Install the 1U air shroud
2. Follow the procedure listed in
3. To verify that the memory module has been installed properly, press F2 during reboot and navigate to System Setup Main
Menu > System BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the
updated capacity of the installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Shut down the
system and ensure that the memory modules are firmly seated in the correct sockets.
5. Run the system memory test in system diagnostics.
Processor and heat sink module
This is a service technician replaceable part only.
Removing the processor and heat sink module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the 1U air
shroud.
NOTE:
The heat sink and processor are hot to touch for some time after the system has been powered off. Allow the
heat sink and processor to cool down before handling them.
NOTE:
The procedure to remove the processor and heat sink module is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Ensure all four anti-tilt wires are in the locked position (outward position), and then using a Torx T30 screwdriver, loosen the
captive nuts on the processor heat sink module (PHM) in the order that is mentioned below:
a. Loosen the first nut three turns.
b. Loosen the nut diagonally opposite to the nut you loosened first.
c. Repeat the procedure for the remaining two nuts.
d. Return to the first nut and loosen it completely.
160
Installing and removing system components
.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
