Table of Contents
Advertisement
2. Follow the procedure listed in the
3.
Remove the 2U air
shroud.
4.
Remove the 1U air
shroud.
5. Remove the
Expansion card riser
6. Remove the
Expansion card riser
NOTE:
The procedure to install the Power button control panel is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Route the control panel cable through the side wall of the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the control panel in the slot on the system.
3. Connect the control panel cable to the connector on the system board.
4. Using the Torx 8, tighten screws from power button control panel assembly.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 170. Installing the Power button control panel for Front Accessed configuration
194
Installing and removing system components
Before working inside your
2.
1.
system.
Advertisement
Table of Contents
