Removing Expansion Card Or Gpu From The Expansion Card Riser 2 - Dell PowerEdge XR7620 Installation And Service Manual

Figure 100. Installing the expansion card riser 3
Next steps
1. If required, reconnect the cables to the expansion card or system board. .
2. Install the Expansion card riser
3. Install the drive cage.
4. Install the 2U air shroud.
5. Follow the procedure listed in
6. Install any device drivers required for the card as described in the documentation for the card.

Removing expansion card or GPU from the Expansion card riser 2

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the 2U air shroud.
4. Remove the drive cage.
5. Remove the Expansion card riser
6. If applicable, disconnect the internal cables that are connected to expansion card.
NOTE: The procedure to remove the expansion card or GPU is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Pull and lift up the expansion card retention latch locks to open. Pull the release black latch away from the riser. Hold the
expansion card by its edges and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
132 Installing and removing system components
2.
After working inside your
Safety instructions.
Before working inside your
2.
system.
system.