Table of Contents
Advertisement
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Disconnect the expansion card cables from the system board and remove the expansion card riser.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
Figure 91. Removing an expansion card from the riser
After working inside the
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
129
Advertisement
Table of Contents
