SRX5400 Firewall Craft Interface Fan LEDs
The fan tray LED are located near the middle of the craft interface.
functions of the fan tray LEDs.
Table 8: Fan LEDs
Label
Color
OK
Green
FAIL
Red
SRX5400 Firewall Craft Interface Online/Offline Buttons
The craft interface has a row of Online/Offline buttons along its lower edge. Each button corresponds to
one slot in the card cage. The Online/Offline buttons are only supported for slots containing MPC
interface cards. You can install MPCs into slots:
• SRX5400–Any slot except bottom slot 0
• SRX5600–Any slot except bottom slots 0 or 1
• SRX5800–Any slot except center slots 0 or 1
NOTE: The Online/Offline buttons are not supported for removal and replacement of SPCs or
SCB.
CAUTION: While traffic is passing through the firewall, particularly if the device is
configured as part of a high availability (HA) cluster, we strongly recommend that you
do not push any of the Online/Offline buttons.
To take an MPC offline using the Online/Offline buttons:
1. Press and hold the corresponding card's Online/Offline button on slot 1 on the craft interface. The
green OK/FAIL LED next to the button begins to blink. Hold until both the button's LED and the
MPC's LED are off.
State
Description
On steadily
Fan tray is functioning normally.
On steadily
Fan tray has failed.
Table 8 on page 15
describes the
15