Reinstalling Cards After Installing The Srx5400 Firewall Without A Lift - Juniper SRX5400 Hardware Manual

Figure 80: Reinstalling the Fan Tray

Reinstalling Cards After Installing the SRX5400 Firewall Without a Lift

To reinstall MPCs, SPCs, and the SCB, follow this procedure for each card (see
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Place the card on an antistatic mat or remove it from its electrostatic bag.
3. Identify the slot on the firewall where it will be installed.
4. Verify that each fiber-optic has a rubber safety cap covering the transceiver. If it does not, cover the
transceiver with a safety cap.
5. Orient the card so that the faceplate faces you.
6. Lift the card into place and carefully align the sides of the card with the guides inside the card cage.
7. Slide the card all the way into the card cage until you feel resistance.
8. Grasp both ejector handles and rotate them clockwise simultaneously until the card is fully seated.
Figure 7):
188