Connector Pinouts For The Srx5400 Firewall Routing Engine Ethernet Port - Juniper SRX5400 Hardware Manual

Table 44: Cable and Wire Specifications for Routing Engine Management and Alarm Interfaces
Port Cable Specification
Routing Engine RS-232 (EIA-232)
console or serial cable
auxiliary interface
RJ-45 Connector Pinouts for the SRX5400 Firewall Routing Engine
Ethernet Port
The port on the Routing Engine labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or
other device that supports out-of-band management).
connector pinout.
Table 45: RJ-45 Connector Pinout for the Routing Engine ETHERNET Port
Pin Signal
1 TX+
2 TX-
3 RX+
4 Termination network
5 Termination network
6 RX-
7 Termination network
Cable/Wire Supplied
One 6-ft (1.83-m) length
with RJ-45/DB-9
connectors
Table 45 on page 162
Maximum Receptacle
Length
6 ft (1.83 m) RJ-45/DB-9 plug
describes the RJ-45
162