Figure 83: Auxiliary and Console Ports
2. Plug the socket DB-9 end into the device's serial port.
NOTE: For console devices, configure the serial port to the following values:
• Baud rate—9600
• Parity—N
• Data bits—8
• Stop bits—1
• Flow control—none
Connecting the SRX5400 Firewall to a Network for Out-of-Band
Management
To connect the firewall Routing Engine to a network for out-of-band management, connect an Ethernet
cable with RJ-45 connectors to the ETHERNET port on the Routing Engine. One Ethernet cable is
provided with the firewall. To connect to the ETHERNET port on the Routing Engine:
1. Plug one end of the Ethernet cable
port on the Routing Engine.
2. Plug the other end of the cable into the network device.
Figure 84: Routing Engine Ethernet Cable Connector
(Figure 84 on page 191
Figure 85 on page 192
shows the port.
shows the connector) into the ETHERNET
191