Srx5400 Firewall Craft Interface Power Supply Leds; Srx5400 Firewall Craft Interface Card Ok/Fail Leds - Juniper SRX5400 Hardware Manual

SRX5400 Firewall Craft Interface Power Supply LEDs

Each power supply has two LEDs on the craft interface that indicate its status. The LEDs, labeled 0
through 3, are located near the middle of the craft interface next to the PEM label.
describes the functions of the power supply LEDs on the craft interface.
Table 6: Power Supply LEDs on the Craft Interface
Label Color State
PEM Green On steadily
Red On steadily

SRX5400 Firewall Craft Interface Card OK/Fail LEDs

Each slot in the card cage has a pair of LEDs on the craft interface that indicates the status of the card
installed in it. The card LEDs are located along the bottom edge of the craft interface and are labeled 0
for the bottom slot reserved for the SCB and 0/1, 1, and 2 for the remaining
describes the functions of the OK and Fail LEDs.
Table 7: Card OK/Fail LEDs
Label Color
OK Green
FAIL Red
Description
Power supply is functioning normally.
Power supply has failed or power input has failed.
State Description
On steadily The card is functioning normally.
Blinking The card is transitioning online or offline.
Off The card is not online.
On steadily The card has failed.
Table 6 on page 14
slots.Table 7 on page 14
14