181
Figure 75: Removing a Power Supply Before Installing the Device
Removing the Fan Tray Before Installing an SRX5400 Firewall Without a Lift
To remove the fan tray (see
Figure 2
):
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Loosen the captive screws on the fan tray faceplate.
3. Grasp the fan tray handle and pull it out approximately 1 to 3 inches.
4. Press the latch located on the inside of the fan tray to release it from the chassis.
5. Place one hand under the fan tray to support it and pull the fan tray completely out of the chassis.