Fax Send Settings; Rotation Sending Setting; Printing Page Number At Receiver - Sharp MX-2300N User Manual

Distinctive Ring Detection
If multiple telephone numbers have been assigned to
your telephone line, the number called can be identified
by its ringing pattern. By using one number for voice
calls and another number for faxes, you can tell which
type of call you are receiving by the ringing pattern. You
can set your machine to automatically receive faxes
when your fax number is called by setting the pattern
that corresponds to your fax number. Six selections are
available.
To use this setting, touch the key of the desired pattern
and touch the [OK] key.

Fax Send Settings

The fax send settings are used to enable or disable certain fax functions to better suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Send Settings] key to configure the
settings.
Auto Reduction Sending Setting
This setting is used to have the size of transmitted faxes
automatically reduced to match the size of the paper in
the receiving machine.
If the setting is disabled, faxes are sent at full size.
Because the size is not adjusted to match the size of the
printing paper, part of the received fax may be cut off.
To enable this setting, select the checkbox
touch the [OK] key.

Rotation Sending Setting

When transmitting an image that is one of the following
sizes, this function rotates the image counterclockwise
90 degrees.
8-1/2" x 11", 5-1/2" x 8-1/2"R, A4, B5R, A5R, 16K
To use this setting, select the checkboxes
desired sizes and touch the [OK] key.
8-1/2" x 11"R and A4R size images are not rotated.
Quick On Line Sending
When this setting is enabled, the machine starts
transmitting a fax as soon as the first page is scanned.
Transmission takes place at the same time as the
remaining pages are being scanned.
If you disable this setting, transmission will not begin
until all pages have been scanned. Note that this setting
and does not apply to manual transmission.
To enable this setting, select the checkbox
touch the [OK] key.

Printing Page Number at Receiver

This setting is used to add the page number to the top of
each fax page printed by the receiving machine.
To enable this setting, select the checkbox
of the touch the [OK] key.
Date/Own Number Print Position
Setting
This setting determines the position of the date and
sender information printed at the top of faxes by the
receiving machine. To have the information printed
outside the transmitted document image, touch the
[Outside the Original Image] key. To have the
information printed inside the document image, touch
[Inside the Original Image] key.
180
and
and