Color Adjustments; Port Switching Method; Auto Color Calibration - Sharp MX-2300N User Manual

Port Switching Method

This setting is used to select when port switching takes
place.
• Switch at End of Job:
The port changes to auto selection when printing
ends.
• Switch after I/O Timeout:
When the time set in
elapses, the port changes to auto selection.
Select one of the keys and touch the [OK] key.
The following two print ports are available on the
machine:
• USB port
• Network port

Color Adjustments

This is used to adjust grayscale and color balance.
Touch [Printer Settings] key and touch the [Color Adjustments] key and configure the settings.

Auto Color Calibration

This is used to perform automatic color correction when
the color in color copies is off. The machine prints a test
patch, the test patch is scanned, and the color is
automatically corrected.
System Settings
Auto Color Calibration
Use 11"x17" or A3 paper for this adjustment.
Press [Execute] to print the test patch.
After the [Execute] key is touched and a test patch is
printed, a message appears prompting you to begin
automatic calibration. Place the test patch on the
document glass as shown below so that the narrow line
of one-side of the paper is on the left and touch the
[Execute] key.
Narrow line
Lay copy paper (about five sheets) that is the same size
as the test patch on top of the placed test patch, and
gently close the automatic document feeder.
"I/O Timeout" (page 102)
Execute
OK
103
• Before executing Auto Color Calibration, check to
see if the registration adjustment is correct. If the
registration adjustment is not correct, perform
"Registration Adjustment" (page 95).
• If the color is still off after performing Auto Color
Calibration, repeating Auto Color Calibration once
again may improve the color.