Removing The Battery - IBM System x3610 Problem Determination And Service Manual

Hide thumbs Also See for System x3610:
Table of Contents

Advertisement

To install a power supply, complete the following steps:
1. Slide the power supply into the bay until the retention latch clicks into place.
2. Connect the power cord for the new power supply to the power-cord connector
3. Route the power cord through the power-supply handle and through any cable
4. Connect the power cord to a properly grounded electrical outlet.
5. Make sure that the power supply status LED on the power supply is lit and is

Removing the battery

The following notes describe information that you must consider when replacing the
battery:
v IBM has designed this product with your safety in mind. The lithium battery must
v If you replace the original lithium battery with a heavy-metal battery or a battery
v To order replacement batteries, call 1-800-IBM-SERV within the United States,
on the power supply.
The following illustration shows the power-supply connectors on the back of the
server.
Power-cord
connector
Power supply
Power
status LED
supply 1
clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you slide the server in and out of the rack.
green, indicating that the power supply is operating correctly.
be handled correctly to avoid possible danger. If you replace the battery, you
must adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
with heavy-metal components, be aware of the following environmental
consideration. Batteries and accumulators that contain heavy metals must not be
disposed of with normal domestic waste. They will be taken back free of charge
by the manufacturer, distributor, or representative, to be recycled or disposed of
in a proper manner.
and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your support center or business partner.
Note: After you replace the battery, you must reconfigure the server and reset
the system date and time.
Power
supply 2
Chapter 4. Removing and replacing server components
57

Advertisement

Table of Contents
loading

This manual is also suitable for:

7942

Table of Contents