Removing The Battery - IBM BladeCenter HS21 Series Problem Determination And Service Manual

4. Firmly press on the indicated locations to seat the expansion card.
5. Install the blade server cover (see "Installing the blade server cover" on page
6. Install the blade server into the BladeCenter unit (see "Installing the blade

Removing the battery

To remove the battery, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. If a Memory and I/O Expansion Blade is installed, remove it (see "Removing an
5. Locate the battery on the system board.
6. Use one finger to press the top of the battery horizontally away from the socket,
7. Lift and remove the battery from the socket.
8. Dispose of the battery as required by local ordinances or regulations.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
81).
server in a BladeCenter unit" on page 78).
on page 75
the blade server from a BladeCenter unit" on page 77 for instructions).
page 80 for instructions).
expansion unit" on page 82).
Battery (BH1)
toward the interior of the blade server.
Chapter 4. Removing and replacing blade server components
97