Toshiba B-EX Series Key Operation Specification page 88

feeding). Moreover, when the [PAUSE] key is pressed before the peel-off pre-print operation, the
remaining number of labels to be printed may not be displayed.
5. Fine adjustment for backward feeding is not reflected during the peel-off pre-print operation
(backward feeding).
6. The peel-off pre-print operation (backward feeding) is not added after auto calibration.
7. Do not use the FEED key function for setting reprints in it.
8.4.1.11 CUT MODE
・ TYPE1 Standard (speed-up function available)
・ TYPE2 Conventional
* Applicable model: B-EX4T3 V3.0 or later
When "TYPE1" (Standard (speed-up function available)) is set, the printer will perform at a higher speed
while overlapping the timing of the feeding the label backward with 5 ips after cutting.
The table below shows the printer behavior according to the combination of the cut mode and backward
feeding speed settings.
System mode setting
Backward
feeding Cut mode
speed
2 ips
Standard
3 ips
2 ips
Conventional
3 ips
Backward feeding speed
Cut issue
Backward Behavior
feeding timing
5 ips Speed-up
2 ips
Conventional
3 ips
83
Reverse
Strip
Command
2 ips
3 ips
2 ips
3 ips
Forward
feeding