FW/BK ACT.
HU CUT/RWD.
RBN SAVE
PRE PEEL OFF
BACK SPEED
TYPE OF RIBBON
AUTO CALIB
Forward
feed
standby
switching action
Note: Models supporting MODE3:
B-EX4T1-G/T-QM/CN C1.2 or later
B-EX4T1-TS25-R V2.1 or later
Head-up operation in the cut
issue mode, or use of the
rewinder
Note: Since the head-up function is
not available to B-EX4T2-G/T/H,
B-EX4D2-G and B-EX4T3-HS, this
parameter is to choose whether to
use the rewinder. The head-up
operation is fixed to OFF.
Use of the ribbon saving
module
Note:
Even
if
"ON:TAG"
"ON:LABEL"
is
selected
B-EX4T2-G/T/4,
B-EX4D2-G
B-EX4T3-HS, the setting and the
printer behavior will automatically be
changed to "OFF".
* "ON:TAG2" and "ON:LBL2" are
supported only by B-EX4T1-TS25-R
V2.0 or later.
The difference between "ON:TAG"
and "ON:TAG2", and between
"ON:LBL" and "ON:LBL2",
respectively, is the distance of
non-print area where a ribbon saving
is performed. (In the case of 8 ips or
faster)
Pre-peel-off process setting
Back feed speed setting
Ribbon type
Applicable model: B-EX4T2,
B-EX4D2
* This parameter is not used for
B-EX4D2.
Auto calibration setting
Note: For B-EX4T2-G/T/H and
B-EX4D2-G, when "ON
TRANS.+Bfeed", "ON
REFLECT+Bfeed" or "ON
ALL+B-feed" is selected, the setting
and the printer behavior will
automatically be changed as follows.
ON TRANS.+Bfeed
57
MODE1
MODE2
MODE3
(Note)
ON
OFF
ON:TAG
or
ON:LABEL
for
and
ON:TAG2 *
ON:LBL2 *
OFF
ON
OFF
STD
LOW
CSO
CSI
OFF
ON TRANS.
ON REFLECT
ON ALL
ON
TRANS+Bfeed
Stops
after
13.7-mm
forward feeding.
Stops
after
6-mm
backward
feeding
3-mm
forward
feeding.
(Only when the cut mode,
thermal transfer, and feed
gap sensor is selected.) In
other cases, the printer
stops
after
13.7-mm
forward feeding.
Stops
after
31.2-mm
forward feeding. This is
an exclusive specification
for issuing RFID media.
The head-up operation is
performed, or the rewinder
is used.
The head-up operation is
not
performed,
or
rewinder is not used.
Used
Head lever position:
"TAG"
Used
Head lever position:
"LABEL"
Used
Head lever position:
"TAG"
Used
Head lever position:
"LABEL"
Not used
Performed
Not performed
3 ips
2 ips
Outside wound
Inside wound
Not performed
Performed with
transmissive sensor
Performed with reflective
sensor
Performed with both
sensors
Back feed follows the ON
TRANS printer behavior.
and
the