Toshiba B-EX Series Key Operation Specification page 84

8.4.1.1 MEDIA LOAD
This function is enabled only when the sensor type is set to other than "None".
OFF The media loading function is disabled. (Same as feeding by pressing the [FEED] key)
・
STD When the [FEED] key is pressed after the printer is tuned on, is reset by a batch reset
・
command or the print head is closed, the printer detects the next gap/black mark and
feeds the media from the sensor to the print start position.
ECO When the [FEED] key is pressed after the printer is reset by a batch reset command or
・
the print head is closed, the printer feeds the media to detect the next gap/black mark
and stops the media at the print start position. At this time, the feed length between
the detected gap/black mark and the home position of the media nearest from the print
head is calculated based on the registered media pitch.
ECO+Bfeed After performing above-mentioned ECO, the printer feeds the media backward for the
・
label pitch length while raising the print head if the following conditions are satisfied.
Note:
Note: In the case the printer cannot detect a gap/black mark while feeding the media, an error occurs
on the following condition. Regarding an error during feeding, refer to the External Equipment
Interface Specification for the B-EX series, Section 7 Error Processing.
OFF
STD
ECO
ECO + Bfeed
8.4.1.2 FORWARD WAIT
・ OFF
・ ON
8.4.1.3 FORWARD WAIT POS.
Max. Min. value
value
5.0 -5.0
・ + (Plus)
・ - (Minus)
Since the head-up function is not available to B-EX4T2, B-EX4D2-G and
B-EX4T3-HS, the setting and the printer behavior will automatically be
changed to "ECO" even if "ECO+Bfeed" is selected for these models.
Hardware An optional ribbon saving module (solenoid) is installed.
Parameter The RBN SAVE parameter is set to TAG or LABEL.
Operation The media pitch falls between 20 mm and 100 mm.
The previous issue mode was Batch. (The issue mode is not
reset by a power off or a printer reset.)
Caution Even if the hardware requirement is not satisfied (the optional
ribbon saving module is not installed), the printer feeds the
media backward when the other requirements are satisfied.
Therefore, this operation is not guaranteed as it is outside of
the specifications.
When the relation between the programmed media pitch (A) and the media pitch
detected by the sensor (B) does not satisfy the following formula, an error will
result:
(A) x 50% ≤ (B) ≤ (A) x 150%
When a gap/black mark is not detected while feeding 1500-mm media, an error
will result.
Disables the auto forward feed wait
Enables the auto forward feed wait
Step Display
0.1 Decimal
Increases the forward feed amount.
Decreases the forward feed amount.
Sign Integer Decimal
digit
Exist 2
79
0-padding
place measure
1 None
Unit of
mm