Toshiba B-EX Series Key Operation Specification page 85

Note:
1. If the pitch of the media used for the previous issue was less than 20 mm, the forward wait will not be
activated regardless of the parameter setting.
<Supplement>
In the case labels with the different pitch (less than 20 mm and 20 mm or longer) are alternately
placed in one label roll, the forward feed is not activated for the labels with the pitch of less than 20
mm. Therefore it stays at the print stop position without being fed backward. Before the next label with
the pitch of 20 mm or larger is printed; however, it is automatically fed backward along with the
previously printed label. This may cause the print data to be printed on the previous label.
2. The media will stay at the forwarded position even if the power is turned off/on, the printer is reset, or
the print head is opened/closed.
8.4.1.4 FW/BK ACT.
・ MODE1 The printer waits for the next issue after the media is forwarded by 13.7 mm.
・ MODE2 When the thermal transfer method and cut issue are selected, the printer feeds the
media backward by 6 mm, then waits for next issue with media forwarded by 3 mm.
・ MODE3 The printer waits for the next issue after the media is forwarded by 31.2 mm (to
prevent an RFID media jam). MODE3 is exclusively for issuing the RFID media.
Note:
1. When MODE2 is selected and the printer starts printing (feeding), it feeds the
* Except for the multi-step acceleration area for short-pitch labels, the print speed
2. When MODE3 is selected and the RBN SAVE parameter is set to "LABEL" or
8.4.1.5 HU CUT/RWD.
Whether or not to activate the head-up action in the cut issue or to use the rewinder in the batch or strip
issue is selected.
* The print head may not be raised depending on the rise of the temperature of the solenoid.
・ OFF The head-up cutting is not performed or the rewinder is not used.
・ ON The head-up cutting is performed or the rewinder is used.
Note: Since the head-up function is not available to B-EX4T2-G/T/H, B-EX4D2-G and B-EX4T3-HS,
this parameter is to choose whether to use the rewinder or not. The head-up operation is fixed
to OFF.
media by 3 mm from this position and temporarily stops. The feed speed for this
3-mm distance to the home position is the maximum speed that can be
accelerated from the previous speed (see below). After the temporary stop, the
printer prints or feeds the media at the specified speed.
203 dpi/600 dpi model: 6 ips
300 dpi/305 dpi model: 5 ips
will be accelerated up to the specified speed when the media has not been
forwarded.
"TAG", the printer will raise the print head while the auto forward feeding function
is performed.
If labels with a pitch of 57.2 mm or less are used, they may be removed from the
backing paper. Therefore, it is required to select "LABEL" or "TAG" for the RBN
SAVE parameter. The speed of the auto forward feeding is fixed to 3 ips.
Applicable model: B-EX4T1-G/T-QM/CN C1.2 or later
80