Toshiba B-EX Series Key Operation Specification page 156

8.12.4.6 CALIB. MODE
・ OFF
・ ON
This parameter is to select whether the RFID calibration function is enabled or not.
When this setting is enabled (ON), the AGC value (CALIB. AGC) and the distance to the read/write
position (CALIB. POSITION) obtained through the RFID calibration become effective. Also, the printer
will automatically feed an RFID media forward/backward for the distance specified by the CALIB.
POSITION parameter before writing/reading RFID tag. Therefore, @003 command's parameters "a"
and "bbbb" become invalid. (For details of the @003 command, refer to the External Equipment
Interface Specification for the B-EX Series.)
When the values obtained by an RFID calibration are set, this parameter will automatically turn ON.
Applicable model: B-EX4T1-G/T-QM/CN C1.4 or later
For details of the RFID calibration, refer to Section 6.7 RFID CALIBRATION.
8.12.4.7 CALIB. AGC
Max. Min. value
value
15 0
By performing the RFID calibration, an AGC (response level from an RFID tag) value is automatically
obtained and set. This parameter is effective only when the CALIB. MODE parameter is set to ON.
Data writing/reading is performed only for the tags having the AGC value equal to or larger than the
AGC value set for this parameter. When the AGC value is less than the one set for this parameter, RFID
WRITE ERROR occurs.
Applicable model: B-EX4T1-G/T-QM/CN C1.4 or later.
For details of the RFID calibration, refer to Section 6.7 RFID CALIBRATION.
8.12.4.8 CALIB. POSITION
Max. Min. value
value
+999.9 -999.9
By performing the RFID calibration, an optimum data read/write position (distance from the home
position) is automatically obtained and set. This parameter is effective only when the CALIB. MODE
parameter is set to ON.
The printer will automatically feed an RFID media forward/backward for the distance specified by the
CALIB. POSITION parameter before writing/reading an RFID tag, which is normally performed with the
@003 command.
The feeding direction is indicated by "+" (backward) and "−" (forward). Setting values ranging from -2.9
mm to +2.9 mm do not affect the read/write position fine adjustment.
Applicable model: B-EX4T1-G/T-QM/CN C1.4 or later.
For details of the RFID calibration, refer to Section 6.7 RFID CALIBRATION.
Step Display
1 Decimal
Step Display
0.1 Decimal
151
Sign Integer Decimal
digit
None 2
Sign Integer Decimal
digit
None 3
0-padding
place measure
0 None
0-padding
place measure
1 None
Unit of
None
Unit of
mm