Toshiba B-EX Series Key Operation Specification page 149

8.12.1.1 ID READ
The printer enters the read test mode, and a read test is performed each time the [ENTER] key is
pressed. When the data of a tag can be read, it is displayed on the LCD.
When the read test failed, the following message is displayed on the LCD.
Error message
MODULE TYPE ERROR
COUNTRY CONFIG ERROR
READ ERROR
Confirm Setting or
set other Tag.
NOT AVAILABLE
NO RESPONSE
READ TIMEOUT
Set a RF-Tag on Ant.
UNKNOWN ERROR
Only the tags selected for the RFID tag type can be read.
If the type of the tag to be read and one selected by the RFID tag type selection do not match, the read
test results in an error. Therefore, RFID tag type shall be selected before the read test is started.
・ Display example
Display
(1) The number tag being read/The total number of tags read
(Mostly, only 1 tag is read.)
(2) For the UHF module, AGC value of the read tag is displayed with decimal number.
(3) Data displayed on the 3rd and 4th lines are expressed with hex. code.
The displayed data differs depending on the module type.
B-EX700-RFID-H1-QM-R: Tag ID
B-EX700-RFID-U2-EU/US-R, B-EX700-RFID-U4-R, B-EX700-RFID-U4-EU/US-R, U4 module
preinstall model (B-EX4T1/EX4T2-GS18/TS18-CN-R): EPC code of EPC area
・ In the case of 16 bytes or more data, only the first 16 bytes are displayed. When data is less than 16
bytes, the vacant digits will be filled with spaces.
・ If more than one tag is read at one time, especially when short-pitch tags are used, pressing the [UP]
or [DOWN] key shows the other tags' data.
Error description
The RFID module type has been set to NONE or a
communication cannot be established.
A country code has not been set.
The type of the tag to be read and one selected by the
RFID tag type selection do not match.
Not supported.
No response from the tag
Timeout
Other errors
(1)
(2)
(3)
144