Toshiba B-EX Series Key Operation Specification page 117

8.6.1.4 PRINT TYPE
・ TRANSFER
・ DIRECT
8.6.1.5 ISSUE TYPE
・ NO CUT
・ WITH CUT
・ PEEL OFF
8.6.1.6 LABEL PITCH
Max. Min. value
value
999 (*1) 5
500 (*2)
*1. Applicable model: B-EX4T1-G/T, B-EX4T2-G/T, B-EX4D2-G
*2. Applicable model: B-EX4T2-H, B-EX4T3-H
8.6.1.7 PAPER FEED
・ NO FEED
・ FEED
Initial values when turning the power on
ISSUE COUNT
PRINT SPEED
SENSOR
PRT TYPE
TYPE
LABEL LEN.
PAPER
Supplementary explanation:
・ Each fine adjustment parameter is effective for test printing. However, the X-coordinate fine
adjustment is excluded.
・ When an error occurs during a test printing, an error message is displayed and printing is stopped.
The ERROR LED is turned on and the ONLINE LED is turned off.
・ The error is cleared by pressing the [CANCEL] key or [ENTER] key, and the display returns to the
TEST PRINT menu. The ERROR LED is turned off and the ONLINE LED is turned on. Printing is not
automatically resumed after the error is cleared.
・ The label size greater than the image buffer length cannot be designated. If it is designated, the
printer prints data corresponding to the image buffer length then stops, or the printer stops because of
an error.
・ When the transmissive sensor is selected, the gap between labels shall be 3 mm.
• For B-EX4T1, the rotary cutter does not support the print speed of 10 ips or faster. When the rotary cutter is
mounted (regardless of the cut issue is specified), the print speed is corrected to 8 ips even if 10 ips is
selected.
Step Display
1 Decimal
112
Sign Integer Decimal
digit
None 3
1 piece
6"/sec.
B-EX4T1-G, B-EX4T2-G, B-EX4D2-G
5"/sec.
B-EX4T1-T, B-EX4T2-T
3"/sec.
B-EX4T2-H, B-EX4T3-H
Transmissive sensor
B-EX4T1, B-EX4T2, B-EX4T3: Thermal transfer
B-EX4D2: Direct thermal
Batch issue
76 mm
Enabled
0-padding
place measure
0 None
Unit of
mm