Toshiba B-EX Series Key Operation Specification page 38

Note:
1. When there is a command error in received command, up to 42 bytes of error command, starting from
the command code, are shown on the 3
(However, [LF] and [NUL] are not displayed. Also, 43 bytes and later are not displayed.)
Display example
(Example 1)
[ESC] PC001;0A00,0300,2,2,A,00,B [LF][NUL]
LCD Display
(Example 2)
[ESC]T20G30[LF][NUL]
LCD Display
(Example 3)
[ESC] PC002;0100,0300,15,15,A,00,00,J0101,+000000000A,Z10,P1[LF][NUL]
LCD display
2. When a command error is displayed, codes other than 20H through 7FH and A0H through DFH are
displayed as "?" (3FH).
3. When the ribbon nearly ending detection is enabled, the error LED blinks at 1-second intervals (ON for
500 msec, OFF for 500 msec) while the printer is in the ribbon nearly ending state.
4. The battery check does not work when the printer is being reset and the RTC is not installed.
5. It is necessary to follow the procedure below to use the RTC function under a low battery condition.
Turn off the power of the printer while it is in an error state. Turn on the power of the printer in the
system mode, set the date and time for the RTC again, then reset the printer to place the printer in the
online state.
* The printer can print the programmed date and time until it is turned off.
rd and 4 th
Command error
Command error
PC001;0A00,0300,2,2,A
,00,B
Command error
Command Error
T20G30
Command error
PC002;0100,0300,15,15
,A,00,00,J0101,+00000
33
lines of the LCD.
Command error