Toshiba B-EX Series Key Operation Specification page 61

BACK
TONE (T)
TONE (D)
RBN (FW) *1
RBN (BK) *1
(RBN WIDTH RBN(FW)
TYPE1) *1
RBN(BK)
(RBN WIDTH RBN(FW)
TYPE2) *1
RBN(BK)
X ADJ.
THRESHOLD<R> *2
THRESHOLD<T> *2
HD ADJ.
*1. The contents vary depending on the model.
Model
B-EX4T1-G/T-QM/CN C1.2 or later
B-EX4T2-G/T-QM/CN C1.2 or later
B-EX4T2-H-QM/CN C1.1A or later
B-EX4D2-G-QM/CN D1.1 or later
Other than above
Note: This parameter is not used for B-EX4D2-G.
*2. For B-EX4T3-HS, threshold values 1 to 5 are printed.
<< PARAMETER SETTINGS >>
Item
MEDIA LOAD
FORWARD WAIT
Backfeed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Take-up)
Ribbon motor drive voltage fine
adjustment (Back tension)
Ribbon motor drive voltage fine
adjustment (Take-up)
Ribbon motor drive voltage fine
adjustment (Back tension)
Ribbon motor drive voltage fine
adjustment (Take-up)
Ribbon motor drive voltage fine
adjustment (Back tension)
X-coordinate fine adjustment
Threshold fine adjustment for the
reflective sensor
Threshold fine adjustment for the
transmissive sensor
Head down timing fine adjustment
* Applicable model: B-EX4T1-TS25-R
V2.0B or later
Parameter
(RIBBON WIDTH
TYPE1)
(RIBBON WIDTH
TYPE2)
RBN(FW)
RBN(BK)
Description
Media loading
Note: Even if "ECO+Bfeed" is
selected for B-EX4T2-G/T/H or
B-EX4D2-G, the setting and the
printer behavior will automatically be
changed to "ECO".
Forward feed standby
switching after issue
56
-9.9 mm to +9.9 mm
-20 to +10 step
-20 to +10 step
-15 to +10 step
-15 to +10 step
-15 to +10 step
-15 to +10 step
-15 to +10 step
-15 to +10 step
-99.5 mm to +99.5 mm
0.0V to 4.0V
0.0V to 4.0V
-30 msec to +30 msec
RBN(FW)
RBN(BK)
RBN(FW)
RBN(BK)
Value to be printed
OFF
STD
ECO
ECO+BFeed
ON
OFF
Disabled
Feeds the detected
gap/mark to the print start
position.
Feeds a gap/mark
positioned between the
print head and the media
sensor, if any, to print the
start position.
Backfeed follows ECO
printer behavior.
Performed
(A fine adjustment value
for the stop position is
also printed.)
Not performed