Installing The Wireless Network Interface Adapter; Points To Note At Installation - Canon iR C2880 Series Service Manual

[2]
F-2-170
Route them beneath the reader power cable [5].
[4]
F-2-171
20) Fix it with two clamps [2] so that there is no bending of the cable [1].
[1]
F-2-172
If voice operation kit does not work, check the following points.
- Is the slide switch on the voice operation board switched to 66MHz?
- TTS-JA/TTS-EN and ASR-JA/ASR-EN should be installed properly in the Service mode: COPIER > Display > VERSION.
<When Stopping the Usage>
1) Press the reset key or the voice recognition button three seconds or longer.
2.17 Installing the Wireless Network Interface
Adapter

2.17.1 Points to Note at Installation

iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
[1]
[2] [3]
[1]
[5]
[2]
19) Route the cable [1] through the cable guide [2] and the wire saddle [3],
attach the cable guide cover [4].
21) Connect the power cable to the power plug.
22) Turn ON the main power switch.
23) Check if the voice operation board is recognized.
Enter service mode.
Select COPIER > DISPLAY > ACC-STS > PCI.
If "Voice Operation" is displayed, that means that the voice operation
board is correctly recognized.
2. Checking Settings
After the power on of the machine, check the following settings to use the
voice guidance kit.
1) Select [Additional Function] > [System Settings] > [Voice Navigation
Management Settings] > [Use Voice Navigation].
2) Check that the setting is ON.
3. Operation Check
<When Using the Voice Operation Kit>
1) Press the reset key or the voice recognition button [1] three seconds or
longer.
2) When the display on the control panel is enclosed with red lines, voice op-
eration kit becomes enabled.
C3080 / iR C3080i / iR C2380i
0018-7271
[1]
F-2-173
Chapter 2
2-41