[1]
[3]
[2]
F-2-177
4) Remove the lower blanking plate [1]. (Do not use the detached blanking
plate.)
- 2 screws [2]
F-2-178
5) Remove the PCB support plate (BW) [2] from the wireless LAN board [1].
(Do not use the detached PCB support plate (BW).)
- 3 screws [2]
[1]
F-2-179
6) Attach the PCB support plate (CL) [2] to the wireless LAN board [1].
- 3 screws [3] (Use the screws removed in step 5)
[3]
[3]
[3]
[1]
[2]
[2]
[3]
[3]
[3]
[1]
F-2-180
7) Connect the wireless LAN board [1] into the lower connector [2] on the
main controller PCB.
- When inserting the board into the connector, be sure that the board is
vertical against the connector.
- Be sure that the wireless LAN board is inserted into the lower connector,
to avoid any danger of the chip resistor [1] being damaged.
If a voice guidance kit is attached, move the voice guidance board [B] to the
upper connector.
[B]
[A]
[A]
[B]
Chapter 2
[2]
[3]
[1]
[1]
2-43