Canon iR C2880 Series Service Manual page 200

Chapter 5
F-5-64
2) Detach the 2 sensors [1] from the sensor base.
- 2 hooks each
F-5-65
5.4.7 Contact Sensor HP Sensor
5.4.7.1 Before Removing the Contact Sensor HP Sensor
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Detach the copyboard glass. (page 5-19)[Removing the Copyboard
Glass]
2) Detach the ADF Reading Glass. (page 5-20)[Removing the ADF Read-
ing Glass]
5.4.7.2 Removing the Contract Sensor Home Position
Sensor
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Pull the drive belt [1] in the direction of the arrow so that the contact image
sensor (CIS) [2] is where indicated in the figure.
F-5-66
2) Remove the CIS home position sensor [3].
- 1 connector [1]
MEMO:
When detaching the sensor, do so as if to push it under the claw [2] found at
the rear.
5-26
Points to note when attaching
After replacing the sensor, pull the drive belt (rear) [1] in the direction of the
arrow so that the contact image sensor (CIS) [2] is returned to the left end.
0014-1386
5.4.8 Original Sensor
5.4.8.1 Before Removing the Original Size Sensor (AB/
Inchconfiguration)
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
0014-1388
1) Detach the copyboard glass. (page 5-19)[Removing the Copyboard
Glass]
5.4.8.2 Removing the Original Size Sensor (AB/Inch-
configuration)
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i
1) Remove the cover.
2) Disconnect the connector [1], and detach the flat cable [2].
F-5-67
F-5-68
F-5-69
0014-1390
0014-1393