[1]
F-14-11
3) Detach the front right cover [1].
- 2 screws [2]
[1]
F-14-12
4) Slide out the cassettes 1 and 2.
5) Check the index position [1] on the adjusting plate.
F-14-13
A. Making Adjustments for the Cassette 1
A-1) Free the 2 claws [1], and pull the grip (right front) [2] in the direction
of the arrow to detach.
F-14-14
A-2) Loosen the fixing screw [2] of the adjusting plate [1].
A-3) By referring to the index you took note of in step 5), move the
adjusting plate back and forth. Moving it toward the rear of the machine
will increase the margin on the image front.
[2]
A-4) Tighten the fixing screw.
A-5) Slide in the cassette 1.
A-6) Make a copy using the cassette 1 as the source of paper; then, check
to see that the margin in the image front direction is 2.5 +/-1.5 mm.
A-7) Mount back the grip (front right).
B. Making Adjustments to the Cassette 2
B-1) Loosen the fixing screw [2] of the adjusting plate [1].
B-2) By referring to the index you took note of in step 5), move the
adjusting plate back and forth. Moving it toward the rear of the machine
will increase the margin on the image front side.
[2]
B-3) Tighten the fixing screw.
B-4) Slide back the cassette 2.
B-5) Make a copy using the cassette 2 as the source of paper; then, check
to see that the margin in the image front direction is 2.5 +/-1.5 mm.
3) Mount back the machine's cassette front right cover.
4) Close the cassette lower right cover and the cassette upper right cover.
2. Adjusting the Margin (2nd side)
1) Make a copy using the cassette 1 as the source of paper; then, check to
make sure that the margin on the front side is 2.5 +/-2.0 mm.
2) If the margin is as indicated, change the adjustment value of the horizontal
registration for the 2nd side for the cassette 1.
- COPIER > ADJUST > FEED-ADJ > ADJ-C1RE
An increase by '1' will decrease the margin on the front side by 0.1 mm.
3) Enter the adjustment value for the horizontal registration of the 2nd side
F-14-15
F-14-16
(–)
(+)
0
2
4
6
8
10
2.5±2.0 mm
F-14-17
Chapter 14
14-5