Sony MVS-8000SF User Manual page 498

Detents
The system defines points called detents at regular intervals on the three-
dimensional space. Pressing the [CTR] button (page 508) in the device control
block sets the current three-dimensional parameter values to the closest detent
points.
The following table shows the interval between successive detents for each
transformation operation mode (see page 499).
Operation mode
Location XYZ
Rotation, Spin
Axis Location
Location Size
Aspect
Perspective (x, y)
Perspective (z)
Skew
a) When a value is smaller than 1, 1/Aspect or 1/Perspective (z) is adjusted to an integral value.
Three-dimensional parameter default values
Each of the transformation operation modes has default values for three-
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] (page 508) button in the device control block
twice in rapid succession.
The following table shows the default parameter values for each
transformation operation mode.
Operation mode
Location XYZ
Rotation, Spin
Axis Location
Location Size
Aspect
Perspective (x, y)
Perspective (z)
Skew
Resetting of parameter values set in the source coordinate space
In some transformation operation modes, if you switch to the target coordinate
space after setting up a three-dimensional transformation in the source
498
DME
Detent interval
1.0000
0.2500
1.0000
0.2500
a)
1.0000
1.0000
a)
1.0000
0.1000
Default value
0.0000
0.0000
0.0000
1.0000
1.0000
0.0000
1.0000
0.0000