Sony MVS-8000SF User Manual page 412

Hide thumbs Also See for MVS-8000SF:

Table of Contents

Setting the operating mode for each switcher bank

To set a desired switcher bank to Multi Program 2 mode, use the following

Assigning output signals for Multi Program 2 mode

To assign signals to outputs

Use the Engineering Setup >Switcher >Config >M/E Output Assign menu.

The difference from standard mode is that OUT1 is fixed, set to PGM1 (main

program), and OUT6 is fixed, set to PGM2 (sub program), and that for the

OUT2 to OUT5 signals you can assign any signal selected from the following.

Each of main and sub can use a maximum of four of the six outputs (OUT1 to

OUT6). The outputs can be used within the following limits.

• OUT1, OUT2: main only

• OUT3, OUT4: can be used for either main or sub

• OUT5, OUT6: sub only

For details, see "Making Settings Required to Use the Software" in Chapter

18 (Volume 3).

To set the background and key configuration

Use the Engineering Setup >Switcher >Config >PGM Config menu.

The following are the differences from standard mode.

Multi Program 2

Shut down the menus. (see page 105.)

Power the switcher and SCU off and on again.

Display the Engineering Setup >Switcher >Config menu.

Select the switcher bank from M/E-1 to M/E-3, and P/P.

In the <M/E Config> group, select [Multi Program2].

In the PGM/PST when using the simple P/P software (see page 424),

[Multi Program2] cannot be selected.

Repeat steps 2 and 3 as required, to set the operating mode for all desired

switcher banks.

PGM1, PGM2, PGM3, PGM4, PVW1, PVW2, K-PVW1, K-PVW2,

CLEAN, SUB CLEAN