Sony MVS-8000SF User Manual page 142

• When the limit value is set to 0%, the wipe effect is completely disabled, and
carrying out the transition produces no change in the image.
• When the limit value is set to the maximum 100%, the image changes in
exactly the same way as when the pattern limit function is off, but when the
transition is completed, the cross-point selections on the background A and
B buses do not interchange.
There are two ways of setting a pattern limit: either by operating the fader lever
to save the fader position, or by using the Wipe menu or DME Wipe menu to
access the Edge/Direction menu for the M/E or PGM/PST bank.
Notes
• A pattern limit only applies when a wipe or DME wipe is selected as the
transition type.
• A pattern limit cannot be applied to an independent key transition (see page
152).
Setting the pattern limit with the fader lever
1
2
142
Executing a Transition
TRANS PVW button
PTN LIMIT button
LIMIT SET button
Move the fader lever to the position corresponding to a particular pattern
size.
• First make sure that the [PTN LIMIT] button is off.
• To check the pattern size on the preview monitor, first press the [TRANS
PVW] button, to select the transition preview mode (see page 150).
Press the [LIMIT SET] button.
Transition control block