Displaying The Macro Attachment List - Sony MVS-8000SF User Manual

• Transition rate indication in the transition execution section: This shows
the fader lever position where the macro attachment is set, as a percentage
value. (Fader lever start position as 0%, end position 100%)
Removing macro attachment settings
To cancel a macro attachment to a button
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block button or user preference button, and press the
background A row button that is flashing. The button for which a macro
attachment was set stops flashing and goes off, and the setting is canceled.
To cancel a macro attachment to a fader lever
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block or user preference button, and press the [LIMIT SET] or
[PRIOR SET] button in the control block containing the fader lever having the
macro attachment set.
To remove all macro attachment settings in a single operation
You can remove all macro attachment settings in a single operation.
1
2
3

Displaying the Macro Attachment List

In the Macro >Attachment menu, you can display the macro attachment list to
check the macro attachment settings.
The macro attachment list includes the following columns.
• Block: Shows the names of control panel blocks.
• Button: Shows the names of macro attachment assigned buttons (of up to 30
characters).
• Reg: Shows the names of assigned registers.
• Name: Shows the names of macro registers.
• Mode: Shows the names of macro modes (Pre/Post/Only/---
854
Macro Attachment Assigning
In the Macro menu, select VF2 'Attachment.'
Press [All Clear].
A confirmation message appears.
Select [Yes].
This deletes all macro attachment setting data.
1)
).