Setting And Canceling A Macro Attachment - Sony MVS-8000SF User Manual

Hide thumbs Also See for MVS-8000SF:

Table of Contents

Setting a macro attachment to a fader lever

You can set a macro attachment to any particular position of a fader lever in the

transition control block.

• In macro-only mode it is not possible to set a macro attachment.

• It is not possible to set a macro attachment to a fader lever in the keyframe

control block or downstream key control block.

Clearing the macro attachments

You can clear all of the macro attachments in a single operation.

Displaying the macro attachment list

You can display the macro attachment settings in the form of a list in the menu

display to check them.

Setting and Canceling a Macro Attachment

Setting a macro attachment to a button

This section describes the example of setting a macro attachment for the

background A row cross-points.

See "Setting a macro attachment to a button" (page 849) for the buttons for

which a macro attachment can be set.

For each of the [PRE MCRO] and [POST MCRO] settings, it is necessary to

make assignments to user preference buttons in the menu control block or

to the utility/shotbox control block. Carry out these assignments in the

Eng Setup >Panel >Prefs/Utility menu. (For details, see "Setting Button

Assignments (Prefs/Utility Menu)" in Chapter 19 (Volume 3).)

Recall the macro register you want to assign to the button. (1 to 250)

For details of recall, see page 828.

To make the setting in pre macro mode, hold down the [PRE MCRO]

button assigned to a utility/shotbox control block button or user preference

button. To make the setting in post macro mode, hold down the similar

[POST MCRO] button, then press the desired button in the background A

Macro Attachment Assigning