Separate Sides Settings; Shaped Video Settings - Sony MVS-8000SF User Manual

Hide thumbs Also See for MVS-8000SF:

Table of Contents

Separate Sides Settings

Applies separate video signals and key signals to the front and back of the

Applying the Separate Sides effect

For each of the front and back sides of the image, specifies whether to handle

input video from the switcher as shaped video (key processed signals).

You can also make these settings for the output video.

• When using an SDI interface, with the [PROC KEY] not selected in the

output destination buttons, then the shaped video function is enabled.

• When using the dedicated interface or SDI interface, with [PROC KEY]

selected in the output destination buttons, since the input video signal to the

first channel is always set to the key processed signal on the switcher, the

DME Special Effect Operations

• When executing combining four channels of DME images, "Mix Color"

and "Ext Video" cannot be selected.

Only if Flat Color is selected in step 1, adjust the following parameters.

In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'

The Video/Key menu appears.

Press [Separate Side], turning it on.

The Separate Sides effect is enabled. If the video and key signals currently

being output to the monitor are the front side, you can select the front

signals. If they are the back side, you can select the back signals. Video and

key signals are selected with the cross-point control blocks of each M/E

bank or the PGM/PST bank.

Setting values

0.00 to 100.00

359.99 to 0.00