User Manual
Note: To measure or simulate TC millivolts, set the TC mV
function
1. Set the applicable software options
2. Complete the electrical connections
3. If necessary change the thermocouple type
4. Set CJ Compensation mode
If Manual CJ compensation is not selected, the
internal cold junction is used to calculate the
thermocouple value.
If using an external cold junction, select check box
on MANUAL CJ COMPENSATION and enter value for
cold junction temperature
06 June 2013
SETTINGS >> TC TYPE
SETTINGS >> MANUAL CJ COMPENSATION
Druck DPI620 Genii
Page 57 of 179