Front Perc Module; Removing The Front Perc Module - Dell PowerEdge T560 Installation And Service Manual

Table 126. Configuration 56: 24x2.5-inch (SAS4/SATA) fPERC12 + GPUx1 on CPU 2 (continued)
Order From
12 SL6_CPU1_PB3 (Signal connector on system
board)
13 SL7_CPU1_PB4 (Signal connector on system
board)
14 SL8_CPU1_PA4 (Signal connector on system
board)
15 BP_DST_SA1 (Backplane 1 signal connector)
16 BP_DST_SA1 (Backplane 2 signal connector)
Figure 95. Configuration 57: 8x3.5 -inch ( SAS/SATA) + Optical disk drive + Tape backup unit
Table 127. Configuration 57: 8x3.5 -inch ( SAS/SATA) + Optical disk drive + Tape backup unit
Order From
1 ODD_PWR (Optical disk drive power
connector on PIB)
2 DD_PWR (Optical disk drive power connector
on PIB) and CTRL_SRC_SA1 (APERC
connector)
3 SL13_PCH_SA1 (Signal connector on system
board

Front PERC module

Removing the front PERC module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Disconnect all the cables connected to the front PERC module.
150 Installing and removing system components
To
BP_DST_PB1 (Backplane signal connector)
CTRL_DST_PA1 (fPERC 12 connector)
CTRL_DST_PB1 (fPERC 12 connector)
CTRL_SRC_SA1_PA1 (Signal connector on fPERC 12)
CTRL_SRC_SB1_PB1 (Signal connector on fPERC 12)
To
ODD (Optical disk drive)
TBU (Tape backup unit) and ODD (Optical disk drive)
BP_DST_SA1 (Backplane signal connector) and ODD (Optical disk
drive)
Safety instructions.
Before working inside your system .