Omron NT31C Reference Manual page 371

Operation of the Memory Link
• PT memory write command
• Numeral memory table write command
• Character-string memory table write command
• Bit memory table write command
• PT memory batch write (FILL) command
• Numeral memory table clear command
• Character-string memory table clear command Page 377
• Bit memory table clear command
Notify Commands
These commands serve to notify the host of the results of operation at the PT.
Only these commands are issued by the PT and, therefore, there is no response
for them.
There are the following five commands.
• Touch switch input notify command
• Numerical input notify command
• Character string input notify command
• Direct area changing notify command
• PT memory changing notify command
Operation Mode Switching Command
This command switches the PT operation mode from RUN mode to transmit
mode. It is issued from the host and switches the PT operation mode.
• PT operation mode switching command Page 384
Re-send Command
This command lets the PT re-send a notify command. It is issued from the host
and the notify command issued last is re-sent from the PT.
• Re-send request command
Error Response
This is a response from the host which is issued when the contents of command
transmitted to the PT was incorrect.
• Error response Page 385
Page 371
Page 372
Page 373
Page 374
Page 375
Page 375
Page 378
Page 378
Page 379
Page 380
Page 381
Page 384
Page 385
Section 4-1
361