Omron NT31C Reference Manual page 223

Recipe
Recipe tables
Recipe table title
Record 1
Record 2
Recipe table title
Parameter 1
Record 1
Record 2
Record 3
Recipe element
Specify the
recipe data
number
Sending Recipe Tables
and Recipe Elements
Using the Support Tool
212
Note a) Names and comments can be set only from the Support Tool. You
cannot change them from the PT.
b) You can also set the following details in the recipe table using the
Support Tool.
Enable or disable parameter editing on the PT ("Lock"; set for each record
individually), and specify the start address for consecutive words allocated
to the host.
Create recipe tables
2. Pasting Recipe Elements on Screens
Create recipe elements on screen using the Support Tool. In the recipe ele-
ment, specify the recipe data number to be displayed or set.
Note You can also set the following details in the recipe elements using the
Support Tool.
Show/hide parameters, and enable or prohibit all recipe touch switches
(i.e., interlock function).
Refer to the NT -series Support T ool V er . 4.1 for W indows Operation Manual
for details.
Recipe table title Parameter 1 Parameter 2 Parameter 3
Record 1
Parameter 1 Parameter 2
Parameter 2 Parameter 3
Recipe table title Parameter 1 Parameter 2
Record 1
Record 2
Record 3
Send recipe tables (i.e., entire sets of recipe data) and recipe elements created
as shown above from the Support Tool to the PT in application units (i.e., send all
screen data in a single operation).
Recipe table title
Record 1
Recipe table title Parameter 1
Record 1
Record 2
Parameter 1 Parameter 2
Recipe table title
Record 1
Record 2
Record 3
Parameter 4
Screen
Parameter 3
Register the recipe element on the screen
Section
Recipe data
Parameter 1 Parameter 2 Parameter 3
Parameter 2
Parameter 3
2-14