Omron NT31C Reference Manual page 301

Screen Display and Notification
Reference:
Switching the Screen by Pressing the Touch Switch with the Switching Screen
Function
Reference: The touch switch operation will be disabled when the touch switch interlock func-
Setting
290
• 9001:
Occurrence history screen
• 9002:
Frequency history screen
• 9020:
Programming Console function screen
• 9021 to 9023:
Device Monitor function screens
• 9030:
Brightness and contrast adjustment screen
S To display overlapping screens, specify the screen number of a parent screen.
S When the PT is started up, the screen of which screen number is stored for
Screen Switch Setting in PT status control area is displayed.
If the screen number stored for Screen Switch Setting is not correct, the screen
is displayed according to the screen number set for Initial Screen of System in
PT Configuration. If the screen number set for Initial screen is not correct, the
error screen (No Starting Screen) is displayed.
S The screen is not switched if elements have not been registered for the speci-
fied screen number.
This method allows the screen to be switched by operation at the PT.
Setting screen No. 5 for the touch switch
tion is being used and the host's interlock bit that controls the touch switch's op-
eration is OFF. (See Disabling T ouch Switches with Interlock Bits on page 357 for
details.)
When creating the screen using the Support Tool, set the Switch Screen function
for a touch switch and specify the screen number of the screen to be switched to.
This screen number should be registered to the screen.
The screen numbers that can be specified are:
• 0001 to 3999:
Screen No. 1 to No. 3999
• 9001:
Occurrence history screen
• 9002:
Frequency history screen
• 9020:
Programming Console function screen
• 9021 to 9023:
Device Monitor function screens
• 9030:
Brightness and contrast adjustment screen
• 9999:
Return to the previous screen
To next screen
Section 3-3
Screen No. 5