Configuration Settings - Omron NT31C Reference Manual

PT Configuration Settings
2-19 PT Configuration Settings
2-19-1 PT Configuration Settings
Apart from the settings of the memory switches at the PT itself, the basic opera-
tion of the PT is also determined by the PT Configuration settings made at the
Support Tool.
This section describes the settings made under PT Configuration. However,
note that the operations at the Support Tool are not described. For details on
these operations, refer to the NT -series Support T ool V er . 4.0 for W indows Op -
eration Manual .
There are the following PT Configuration settings.
PT Model
Set the type of PT to be connected. (Refer to 3-1 Screen Creation Procedure
(page 278).)
NT30/620 Compatible Mode
When you want to use screen data from an earlier PT (NT30, NT30C, NT620C,
or NT625C) in an NT31, NT31C, NT631, or NT631C, you can set NT30/620
compatible mode to improve compatibility and reduce the editing required to
make the screen data and the user program compatible.
The screen data will be checked by default when screen data from an earlier PT
(NT30, NT30C, NT620C, or NT625C) is converted for use in a V2 version of an
NT31/NT31C or NT631/NT631C PT. Refer to Appendix C for details on the
NT30/620 compatible mode.
PC Vendor
Set the direct connection type to one of the options in the following table.
Setting Direct access type
OMRON OMRON
Mitsubishi_A Mitsubishi A
Mitsubishi_Fx Mitsubishi FX
MEMLINK Memory link
Font Type
Set the display font to one of the options in the following table.
Setting
CP437
ISO 8859-1
For details, refer to the keycode tables in Appendix E (page 447).
Comments
Set a comment relating to screen data here. This comment is displayed on the
screen on manual transmission of memory unit.
PT Control Area/PT Notify Area
Set the allocated words for the PT status control area, PT status notify area and
window control area here. Refer to 2-2 Areas for Control/Notification (page 46).
Initial Screen
Set the screen number of the screen that is displayed when PT operation starts.
However, note that the screen set here is displayed as the initial screen only
when the setting made for the screen switch setting word in the PT status control
area is not a correct screen number. For details, refer to Functions of the PT Sta -
tus Control Area (page 47).
History Setting
Set the processing method when the record areas for the display history function
and alarm history function become full. Refer to Alarm list/history function (page
80).
Section
Remarks
---
The special system program provided y g
with the Support Tool is required. i h h S T l i
---
Font type
Code Page 437
ISO 8859/1
2-19
i d
275