Nortel Media Gateway 3200 User Manual page 263

H.248 User's Manual
ini File Field Name
QCELP8Rate
RFC2198PayloadType
RFC2833RxPayloadType
RFC2833TxPayloadType
RTPRedundancyDepth
SITDetectorEnable
TestMode
UserDefinedToneDetectorEnabl
Version SN09
Table 12-4: Media Processing Parameters
Description
0 = Variable Rate
1 = 1 kbps
2 = 3 kbps
3 = 7 kbps
4 = 13 kbps
This parameter is used to configure
the QCELP8 coder bit rate.
0 = Variable Rate
1 = 1 kbps
2 = 2 kbps
3 = 4 kbps
4 = 8 kbps
This parameter sets the RFC 2198
(RTP Redundancy) packet's
parameter 'RTP Payload Type'.
Controls the RFC 2833 Rx Relay
RTP Payload type.
Controls the RFC 2833 Tx Relay
RTP Payload type.
Enables or disables generation of
RFC 2198 redundancy packets.
0 = Disable; 1 = Enable
Enables or disables SIT (Special
Information Tone) detection
according to the ITU-T
recommendation E.180/Q.35.
0 = Disable; 1 = Enable
Defines the type of testing mode
applied:
0 = Coder Loopback performs an
encoder/decoder loopback inside the
DSP device
1 = PCM Loopback loops back an
incoming PCM to the outgoing PCM.
2 = ToneInjection generates a 1000
Hz tone to the outgoing PCM
3 = NoLoopback sets the channel to
work in normal mode
Enables or disables detection of User
263
12. Appendix - Individual ini File Parameters
Host/Manual
Default Value
104
Valid
Range
0 0 to 4
96 to 127
96 96 to 127
96 96 to 127
0 0 or 1
0 0 or 1
3 0 to 3
0 0 or 1
October 2006