Nortel Media Gateway 3200 User Manual page 204

4. Configure the initial BootP/TFTP parameters required, and click OK (refer to the
Appendix, ''BootP/TFTP Server'' on page 223).
5. Reset the MG 3200; the MG 3200's cmp and Software Upgrade Key files are loaded
to the MG 3200.
8.4.6.3.6 Verifying that the Key was Successfully Loaded
After installing the key, you can determine in the Embedded Web Server's read-only 'Key
features:' panel (Software Update menu > Software Upgrade Key) (refer to Figure H-1)
that the features and capabilities activated by the installed string match those that were
ordered.
You can also verify that the key was successfully loaded to the MG 3200 by accessing the
Syslog server. For detailed information on the Syslog server, refer to ''Syslog'' on page 209.
When a key is successfully loaded, the following message is issued in the Syslog server:
"S/N___ Key Was Updated. The Board Needs to be Reloaded with ini file\n"
8.4.6.3.7 Troubleshooting an Unsuccessful Loading of a Key
If the Syslog server indicates that a Software Upgrade Key file was unsuccessfully loaded
(the SN_ line is blank), take the following preliminary actions to troubleshoot the issue:
Open the Software Upgrade Key file and check that the S/N line of the specific MG
3200 whose key you want to update is listed in it. If it isn't, contact Nortel.
Verify that you've loaded the correct file and that you haven't loaded the MG 3200's ini
file or the CPT ini file by mistake. Open the file and ensure that the first line is
[LicenseKeys].
Verify that you did not alter in any way the contents of the file.
8.4.6.3.8 Abort Procedure
Reload the key you backed-up in ''Backing up the Current Software Upgrade Key'' on page
81 to restore your device capabilities to what they originally. To load the backed-up key use
the procedure described in ''Loading the Software Upgrade Key''.
User's Manual 204
MG 3200
Document # LTRT-72704