Nortel Media Gateway 3200 User Manual page 132

8.1.5.1.2 Configuration of Community Strings via SNMP
To configure read-only and read-write community strings, the EM must use the
srCommunityMIB. To configure the trap community string, the EM must also use the
snmpVacmMIB and the snmpTargetMIB.
Note:
To add a read-only community string, v2user, take this step:
Add a new row to the srCommunityTable with CommunityName v2user and
GroupName ReadGroup.
To delete the read-only community string, v2user, take these 2
steps:
1. If v2user is being used as the trap community string, follow the procedure for changing
the trap community string. (See below.)
2. Delete the srCommunityTable row with CommunityName v2user.
To add a read-write community string, v2admin, take this step:
Add a new row to the srCommunityTable with CommunityName of v2admin and
GroupName ReadWriteGroup.
To delete the read-write community string, v2admin, take these 2
steps:
1. If v2admin is being used as the trap community string, follow the procedure for
changing the trap community string. (See below.)
2. Delete the srCommunityTable row with a CommunityName of v2admin and
GroupName of ReadWriteGroup.
To change the only read-write community string from v2admin to
v2mgr, take these 4 steps:
1. Follow the procedure above to add a read-write community string to a row for v2mgr.
2. Set up the EM such that subsequent set requests use the new community string,
v2mgr.
3. If v2admin is being used as the trap community string, follow the procedure to change
the trap community string. (See below.)
4. Follow the procedure above to delete a read-write community name in the row for
v2admin.
User's Manual
Support for the SR-COMMUNITY-MIB is to be discontinued and it is to be
replaced by the standard snmpCommunity MIB in the next applicable
release.
132
MG 3200
Document # LTRT-72704