Nortel Media Gateway 3200 User Manual page 262

ini File Field Name
MFSS5DetectorEnable
MFTransportType
MinDTMFDigitsInCIDString
ModemBypassPayloadType
NSEMode
NSEPayloadType
PDPattern
PDThreshold
PrerecordedTonesFileName
QCELP13Rate
User's Manual
Table 12-4: Media Processing Parameters
Description
Enables or disables detection of MF
SS5 line signaling.
0 = Disable; 1 = Enable
Defines the type of MF transport.
0 = Erase MFs from voice transport
not relayed to remote
2 = MFs not erased are not relayed
to remote
3 = MFs are muted from the voice
stream and relayed according to RFC
2833
Determines the miniumum number of
DTMF digits in a DTMF-based Caller
ID string.
Modifies the Modem Bypass Mode
RTP packet's payload type.
If congestion (if the selected payload
type is already used for other
coders/modes), then a
TP_SETUP_PARAMETER_INVALID
_ERROR is issued and the payload
type is set to the default value (103).
It is the user's responsibility to avoid
congestion with other payload types.
Enables or disables Cisco's NSE fax
/ modem automatic pass-through
mode.
0 = Disable; 1 = Enable
Users can use this parameter to
modify the NSE packet's payload
type.
Defines the patterns that can be
detected by the Pattern Detector.
Defines the number of consecutive
patterns to trigger the pattern
detection event.
Defines the name (and path) of the
file containing the Prerecorded
Tones.
Range = String of ASCII characters
This parameter is used to configure
the QCELP13 coder bit rate.
262
MG 3200
Host/Manual Valid
Default Value Range
0 0 or 1
3 0 to 3
0 0 to 26
103 0 to 127
0 0 or 1
105 96 to 127
- 0 to 0xFF
5 0 to 31
- See
Descr.
0 0 to 4
Document # LTRT-72704